Now things have happends

Hello everyone!

Long time, no see!

Now we have come to almost the end of the 3D printer project. We have had some problems on the way. The Mega boards “volt regulator” got burned so i had to make some modifications to my Ramps 1.4 board and give it 5v from my power supply. It works very good now. Later on the printer worked on all axis until one day when nothing works on the Z axis. The other axis works great. I understood that i have to split up the Z-axis 2 stepper motors from one A4988 stepper motor driver to two A4988 stepper motor driver in paralell. We will see if it works!

Detta inlägg är publicerat i 3D Printer, Arduino, Development, DIY, Electronics, Okategoriserade. Bokmärk permalink. Stängt för kommentarer och trackbacks.